1. Snap ring
2. Axle case
IMPORTANT: Do not reuse snap ring. Discard and
replace ring with new one.
B. Remove snap ring from the axle case. Remove
axle shaft from case.
IMPORTANT: When replacing ball bearings, both
ball bearings must be replaced as a set.
4. Disassemble input shaft assembly.
1. Input shaft
A. On Workman MD, remove governor sleeve from
the input shaft.
Workman MD/MDX
2
4
3
1
Figure 38
3. Axle shaft
4. Ball bearing
C. Ball bearing roller balls must be free of deforma-
tion and scoring. Ball bearing must spin freely and
have minimum axial play. Replace ball bearing as
necessary.
1
2
Figure 39
2. Governor sleeve (Workman MD)
Page 5 - - 27
Drive Train