Toro Workman MD Service Manual page 193

Removal (Fig. 33)
NOTE: If cargo box has been replaced with newer box
design, refer to Cargo Box (Serial Numbers Above
311000000) in this section.
1. Park machine on a level surface, stop engine, set
parking brake and remove key from the ignition switch.
2. Disassemble cargo box as necessary using Figure
33 as a guide.
Workman MD/MDX
Installation (Fig. 33)
1. Assemble cargo box using Figure 33 as a guide.
A. When installing tailgate and tailgate hardware,
use torque specifications identified in Figure 33.
B. Adjust latch pin (item 20) so that cargo box is tight
to frame when latched.
Rev. A
Page 7 - - 45 Chassis