Toro Workman MD Service Manual page 102

1. Side gear
2. Pinion gear
D. Install remaining side gear to the pinion gears.
40 to 45 ft- -lb
(54 to 61 N- -m)
IMPORTANT: The length from the outer most side of
each ball bearing must be from 123.3 to 124.0 mm
(Fig. 58).
F. If ball bearings were removed, press new ball
bearings onto differential case and gear 62.
Drive Train
2
Figure 61
3. Gear 62
4. Differential case
E. Secure gear 62 to the differential case with six (6)
bolts. Torque bolts in a crossing pattern from 40 to 45
ft- -lb (54 to 61 N- -m).
Figure 62
G. The differential assembly should appear as
above when assembled.
Page 5 - - 40
3
1
4
Workman MD/MDX