Toro Workman MD Service Manual page 106

6. Install input shaft, center shaft and differential as-
semblies to the case.
1. Shift shaft
A. Insert fork of the shift shaft to the clutch groove of
the center shaft assembly.
1. Center shaft assembly
2. Shift shaft
B. Replace oil seals for the input and selector shafts
on the case (LH) if cracked, nicked or distorted such
that they would not hold a proper seal.
IMPORTANT: Make sure to not damage the oil seal
when installing the input shaft.
Drive Train
2
2
3
Figure 69
2. Clutch groove
1
Figure 70
3. Input shaft
4. Differential assembly
C. Install center shaft assembly with shift shaft and
differential assembly. Then, install input shaft as-
sembly. Lower differential assembly, center shaft as-
sembly and input shaft assembly into the case at the
same time.
Page 5 - - 44
1
4
Workman MD/MDX