2. Assemble the center shaft assembly.
7
1. Pin clutch
2. Center shaft
3. Gear 47
4. Gear 55
5. Collar
NOTE: Before assembling, apply molybdenum disul-
fide grease to the inside of gears 47 and 55.
1. Ball bearing
B. Press ball bearings onto the center shaft using a
bearing press.
Workman MD/MDX
4
1
9
136.8 to 137.1 mm
Figure 55
6. Gear (small)
7. Bearing
8. Bearing
9. Spacer
2
Figure 56
2. Ball bearing
Page 5 - - 37
3
8
6
5
5
2
A. Slide pin clutch onto the centershaft. Install gears
47 and 55 onto shaft noting correct orientation of
gears. Slide collars, small gear and spacer onto the
center shaft.
1
C. Make sure distance from one ball bearing outer
edge to the other ball bearing outer edge is 136.8 to
137.1 mm (Fig. 55).
Drive Train