Toro Workman MD Service Manual page 53

Disassembly
DANGER
Gasoline is flammable. Use caution when storing
or handling it. Wipe up any spilled fuel before
starting the engine.
1. Inspect carbon cannister and attached hoses for
damage or obvious leaks. A damaged or leaking cannis-
ter should be replaced.
2. Remove components as needed using Figure 15 as
a guide.
A. If check valve (item 8 in Fig. 15) is removed, note
direction of arrow on valve body for assembly pur-
poses (Fig. 16).
B. Note location of hose clamps for assembly pur-
poses.
Assembly
1. Install all removed components using Figure 15 as a
guide.
A. If check valve (item 8 in Fig. 15) was removed,
make sure that arrow on valve body points toward
engine.
B. Make sure that fuel hoses are not kinked after
installation. Also, secure hoses with hose clamps.
Workman MD
7
4
5
6
1. Fuel tank
2. Carbon canister
3. Rollover valve
4. Fuel hose (tank vent)
5. Fuel hose
3
1. Check valve
2. Directional arrow
1
3
1. Top of carbon canister
2. Fitting to rollover valve
Page 4 - - 17 Rev. B
8
9
3
4
2
Figure 15
6. Fresh air filter
7. Fuel hose (purge hose)
8. Check valve
9. Fuel hose (to engine)
1
2
4
Figure 16
3. Fitting from canister
4. Fitting to engine
Figure 17
3. Fitting to engine
Single Cylinder Gasoline Engine
1
2