Step 4 Starting The Fax Job - Fuji Xerox ApeosPort-IV C7780 User Manual

Step 4 Starting the Fax Job

The following describes how to start a fax job.
1
Press the <Start> button.
Important • If the document has been loaded in the
• Fax cannot be sent if a copy protection
Note • Depending on the settings, the screen to
• If a problem occurs, an error message
If you have more documents
If you have more documents to fax, select [Next Original] on the touch screen while the
current document is being scanned. This allows you to send the documents as one set
of data.
2
While documents are being scanned, select
[Next Original].
Note • When using the document feeder, load
• When [Next Original] is displayed on the
• You can change the scan settings of the
3
Load the next document.
4
Press the <Start> button.
If you have more documents, repeat steps 3 and 4.
5
When all documents have been scanned,
select [Last Original].
document feeder, do not hold down the
document while it is being conveyed.
code is detected
re-enter the recipient may be displayed
after pressing the <Start> button. In this
case, re-enter the recipient.
appears on the touch screen. Solve the
problem according to the message.
the next document after the machine has
finished scanning the first document.
screen shown on the right and no
operation is performed during a certain
period of time, the machine automatically
assumes that there are no more documents.
next document by selecting [Resolution],
[Original Size], and [Lighten/Darken] that
are displayed after selecting [Next
Original].
Fax Procedure
<Start> button
4
171