Starting Rate (Selecting A Communication Mode) - Fuji Xerox ApeosPort-IV C7780 User Manual

4 Fax

Starting Rate (Selecting a Communication Mode)

You can select a communication mode based on the features of the remote machine.
G3 is the international standard for facsimile transmissions established by the ITU-T.
When you use speed dialing, one touch buttons, group dial number or address book to specify a recipient
registered in an address number, the communication mode currently set to the address number is set and
cannot be changed. For information on how to register address numbers, refer to "5 Tools" > "Setup" >
"Add Address Book Entry" in the Administrator Guide.
You can change the default mode of [Starting Rate] in the System Administration mode. For
information on how to change the default mode, refer to "5 Tools" > "Fax Service Settings" > "Fax
Defaults" > "Starting Rate" in the Administrator Guide.
1
Select [Starting Rate].
2
Select any option.
4
G3 Auto
Select this mode if the remote machine is G3 compatible. This mode is normally
selected.
Depending on the reception capabilities of the remote machine, the machine
automatically switches modes in the following order: G3 Unique ECM
ITU-T G3 ECM
Forced 4800 bps
Select this mode when transmitting over noisy or poor telephone lines, as can be the
case with overseas calls.
Also select this mode when transmitting over noisy or poor telephone lines
domestically.
216
ITU-T G3.
G3 Unique