Table of Contents
Advertisement
REMOTE PROGRAMMING
NX-828H
HYBRID KEY SYSTEM
programming can be done at this time. When the NX-828H header is displayed, you can enter
MMC 20, type the necessary passcode to open programming and begin the on-site programming
session.
NOTE : CUSTOMER in the header will display the name assigned in MMC 81.
2.3 Programming Protocol
The NX-828H will only recognise keystrokes on the PC keyboard that have been assigned as an
NX24 keyset equivalent. These keystrokes are fixed and are not programmable. Use the PC
equivalent in place of the NX24 key as called for in MMC programming procedures. These
keystrokes are described below. Dial pad numbers may be entered using the standard number
keys of the PC keyboard or the number pad on the right-hand side of the PC keyboard
(if equipped).
A-4
Hide quick links:
Advertisement
Chapters
Table of Contents
