External Paging; Smdr / Remote Programming - Samsung NX-828 Technical Manual

NX-828
HYBRID KEY SYSTEM

6.3 External Paging

Customer-provided paging equipment can be connected to the PAGING jack using a modular
jack when the NX-DPH/PAGING card is installed (Figure 2-22).
P A G I N G
P AG ING
Figure 2-22 Connecting External Paging

6.4 SMDR / Remote Programming

For Station Message Detailed Recording (SMDR) or remote programming, the NX-SMDR/
R-MMC card should be installed.
The NX-SMDR/R-MMC card provides two (2) serial I/O ports: R-MMC and SMDR. The port
marked 'R-MMC' is used for remote programming and the port marked 'SMDR' is used for
SMDR (Figure 2-23). Port parameters can be set using MMC 80 (see Programming section).
SMDR provides details of outside calls made through the system that can be sent to a
customer-provided printer, data buffers or a CRT. Connect the cable for SMDR as shown
below.
SMDR
(9 PIN)
RXD 2
TXD 3
SGND 5
CTS 8
For remote programming, a customer-provided modem should be connected. Connect
the cable for remote programming as shown below.
R-MMC
(9 PIN)
RXD 2
TXD 3
SGND 5
DTR 4
CTS 8
PRINTER
(25 PIN)
2 TXD
3 RXD
7 SGND
20 DTR
MODEM
(25PIN)
3 RXD
2 TXD
7 SGND
6 DSR
20 DTR
2 - 20
INSTALLATION