Samsung NX-828 Technical Manual page 172

NX-828H
HYBRID KEY SYSTEM
Appendix D
1. External Forward
If you want to use FWE(External Call Forward) function, you must do the following steps.
1.1 Make a "FWE" key in programmable key using MMC 71 or MMC 72
1.2 Make a key extender for "FWE" key.
- extender number should be 00 ~ 99(speed dial list no.)
1.3 Store speed dial number to the speed list assigned in "FWE" extender.
- If you make a "FWE00" key, then you must store the speed number for speed list "00".
1.4 Press "FWE" key, then External Call Forward is setted.
Note) External Call Forward function works only for incoming trunf call.
This means that External Call Forward is C.O to C.O call.
And External Call Forward does not work for group call.
You must assign station number in MMC 43.
Note) Each trunk line must be in for "TRK FWRD" in MMC 42.
Note) If External Call Forward is working, then C.O to C.O call is disconnected after C.O to C.O
disconnect time(MMC 50).
A-11
EXTERNAL FORWARD