Replacing Transmission Oil Filter Cartridge; Checking Hydraulic Hose - Kubota F2890 Manual

BReplacing Transmission Oil Filter
Cartridge
To avoid serious injury:
A Be sure to stop the engine and remove the key
before changing the oil filter cartridge.
A Allow transmission
sufficiently; oil can be hot and may cause
burns.
1. The oil filter cartridge must be changed every 200
service hours.
(1) Oil filter cartridge
(1) Oil filter cartridge
2. Remove the oil filter cartridge by using the filter
wrench.
3. Apply a slight coat of oil onto the cartridge gasket.
4. To install the new cartridge, screw it in by hand. Over
tightening may cause deformation of the rubber
gasket.
5. After the new cartridge is replaced, the transmission
fluid level normally decreases a little. Add fluid if
necessary.
6. Check for oil leaks around the filter gasket.
A To prevent serious damage to a hydraulic system,
replace a highly efficient, 10 m filter. Use only a
genuine KUBOTA filter.
case to cool down
(A) Screw
A When using the auxiliary hydraulics, replace the filter
cartridge after initial 50 service hours of operation.
BChecking Hydraulic Hose
To avoid serious injury:
A Be sure to stop the engine and remove the key
before checking and replacing hydraulic hose.
A Allow transmission
sufficiently; oil can be hot and may cause
burns.
Check to see if hydraulic hoses are properly fixed every
200 hours of operation.
1. Check to see that all lines and hose clamps are tight
and not damaged.
2. If hoses and clamps are found worn or damaged,
replace or repair them at once.
(1) Power steering hoses
(1) Power steering hoses
(2) Pump hoses
PERIODIC SERVICE
case to cool
51
down