ZyXEL Communications ZyWALL 1100 User Manual page 116

Table 46 Monitor > System Status > Cellular Status (continued)
LABEL
Status
Service Provider
Chapter 6 Monitor
DESCRIPTION
• No device - no mobile broadband device is connected to the ZyWALL/USG.
• No Service - no mobile broadband network is available in the area; you
cannot connect to the Internet.
• Limited Service - returned by the service provider in cases where the SIM
card is expired, the user failed to pay for the service and so on; you cannot
connect to the Internet.
• Device detected - displays when you connect a mobile broadband device.
• Device error - a mobile broadband device is connected but there is an error.
• Probe device fail - the ZyWALL/USG's test of the mobile broadband device
failed.
• Probe device ok - the ZyWALL/USG's test of the mobile broadband device
succeeded.
• Init device fail - the ZyWALL/USG was not able to initialize the mobile
broadband device.
• Init device ok - the ZyWALL/USG initialized the mobile broadband card.
• Check lock fail - the ZyWALL/USG's check of whether or not the mobile
broadband device is locked failed.
• Device locked - the mobile broadband device is locked.
• SIM error - there is a SIM card error on the mobile broadband device.
• SIM locked-PUK - the PUK is locked on the mobile broadband device's SIM
card.
• SIM locked-PIN - the PIN is locked on the mobile broadband device's SIM
card.
• Unlock PUK fail - Your attempt to unlock a WCDMA mobile broadband
device's PUK failed because you entered an incorrect PUK.
• Unlock PIN fail - Your attempt to unlock a WCDMA mobile broadband device's
PIN failed because you entered an incorrect PIN.
• Unlock device fail - Your attempt to unlock a CDMA2000 mobile broadband
device failed because you entered an incorrect device code.
• Device unlocked - You entered the correct device code and unlocked a
CDMA2000 mobile broadband device.
• Get dev-info fail - The ZyWALL/USG cannot get cellular device information.
• Get dev-info ok - The ZyWALL/USG succeeded in retrieving mobile broadband
device information.
• Searching network - The mobile broadband device is searching for a
network.
• Get signal fail - The mobile broadband device cannot get a signal from a
network.
• Network found - The mobile broadband device found a network.
• Apply config - The ZyWALL/USG is applying your configuration to the mobile
broadband device.
• Inactive - The mobile broadband interface is disabled.
• Active - The mobile broadband interface is enabled.
• Incorrect device - The connected mobile broadband device is not compatible
with the ZyWALL/USG.
• Correct device - The ZyWALL/USG detected a compatible mobile broadband
device.
• Set band fail - Applying your band selection was not successful.
• Set band ok - The ZyWALL/USG successfully applied your band selection.
• Set profile fail - Applying your ISP settings was not successful.
• Set profile ok - The ZyWALL/USG successfully applied your ISP settings.
• PPP fail - The ZyWALL/USG failed to create a PPP connection for the cellular
interface.
• Need auth-password - You need to enter the password for the mobile
broadband card in the cellular edit screen.
• Device ready - The ZyWALL/USG successfully applied all of your configuration
and you can use the mobile broadband connection.
This displays the name of your network service provider. This shows Limited
Service if the service provider has stopped service to the mobile broadband card.
For example if the bill has not been paid or the account has expired.
ZyWALL/USG Series User's Guide
116