The Anti-Spam Black Or White List Add/Edit Screen - ZyXEL Communications ZyWALL 1100 User Manual

30.5.1 The Anti-Spam Black or White List Add/Edit Screen

In the anti-spam Black List or White List screen, click the Add icon or an Edit icon to display the
following screen.
Use this screen to configure an anti-spam black list entry to identify spam e-mail. You can create
entries based on specific subject text, or the sender's or relay's IP address or e-mail address. You
can also create entries that check for particular header fields and values.
Figure 324 Configuration > UTM Profile > Anti-Spam > Black/White List > Black List (or White List)
> Add
The following table describes the labels in this screen.
Table 198 Configuration > UTM Profile > Anti-Spam > Black/White List > Black/White List > Add
LABEL
Enable Rule
Type
Mail Subject
Keyword
Sender or Mail
Relay IP Address
Sender or Mail
Relay IPv6 Address
Netmask
Chapter 30 Anti-Spam
DESCRIPTION
Select this to have the ZyWALL/USG use this entry as part of the black or white list.
To actually use the entry, you must also turn on the use of the list in the corresponding
list screen, enable the anti-spam feature in the anti-spam general screen, and configure
an anti-spam policy to use the list.
Use this field to base the entry on the e-mail's subject, source or relay IP address,
source e-mail address, or header.
Select Subject to have the ZyWALL/USG check e-mail for specific content in the subject
line.
Select IP Address to have the ZyWALL/USG check e-mail for a specific source or relay
IP address.
Select IPv6 Address to have the ZyWALL/USG check e-mail for a specific source or
relay IPv6 address.
Select E-Mail Address to have the ZyWALL/USG check e-mail for a specific source e-
mail address or domain name.
Select Mail Header to have the ZyWALL/USG check e-mail for specific header fields and
values. Configure black list header entries to check for e-mail from bulk mail programs
or with content commonly used in spam. Configure white list header entries to allow
certain header values that identify the e-mail as being from a trusted source.
This field displays when you select the Subject type. Enter up to 63 ASCII characters of
text to check for in e-mail headers. Spaces are not allowed, although you could
substitute a question mark (?). See
This field displays when you select the IP Address type. Enter an IP address in dotted
decimal notation.
This field displays when you select the IPv6 Address type. Enter an IPv6 address with
prefix.
This field displays when you select the IP type. Enter the subnet mask here, if
applicable.
ZyWALL/USG Series User's Guide
490
Section 30.5.2 on page 491 for more details.