ZyXEL Communications ZyWALL 1100 User Manual page 111

• Source address
• Destination address
• Number of bytes received (so far)
• Number of bytes transmitted (so far)
• Duration (so far)
You can look at all established sessions that passed through the ZyWALL/USG by user, service,
source IP address, or destination IP address. You can also filter the information by user, protocol /
service or service group, source address, and/or destination address and view it by user.
Click Monitor > System Status > Session Monitor to display the following screen.
Figure 93 Monitor > System Status > Session Monitor
The following table describes the labels in this screen.
Table 41 Monitor > System Status > Session Monitor
LABEL DESCRIPTION
View Select how you want the established sessions that passed through the
be displayed. Choices are:
• sessions by users - display all active sessions grouped by user
• sessions by services - display all active sessions grouped by service or protocol
• sessions by source IP - display all active sessions grouped by source IP address
• sessions by destination IP - display all active sessions grouped by destination IP
address
• all sessions - filter the active sessions by the User, Service, Source Address, and
Destination Address, and display each session individually (sorted by user).
Refresh Click this button to update the information on the screen. The screen also refreshes
automatically when you open and close the screen.
The User, Service, Source Address, and Destination Address fields display if you view
all sessions. Select your desired filter criteria and click the Refresh button to filter the list
of sessions.
User This field displays when View is set to all sessions. Type the user whose sessions you
want to view. It is not possible to type part of the user name or use wildcards in this field;
you must enter the whole user name.
Service This field displays when View is set to all sessions. Select the service or service group
whose sessions you want to view. The ZyWALL/USG identifies the service by comparing
the protocol and destination port of each packet to the protocol and port of each services
that is defined.
Source This field displays when View is set to all sessions. Type the source IP address whose
sessions you want to view. You cannot include the source port.
Destination This field displays when View is set to all sessions. Type the destination IP address
whose sessions you want to view. You cannot include the destination port.
Rx This field displays the amount of information received by the source in the active session.
Chapter 6 Monitor
ZyWALL/USG Series User's Guide
111
ZyWALL/USG
to