ZyXEL Communications ZyWALL 1100 User Manual page 56

Figure 42 WAN and ISP Connection Settings: (PPTP Shown)
The following table describes the labels in this screen.
Table 16 WAN and ISP Connection Settings
LABEL DESCRIPTION
ISP Parameter This section appears if the interface uses a PPPoE or PPTP Internet connection.
Encapsulation This displays the type of Internet connection you are configuring.
Authentication Use the drop-down list box to select an authentication protocol for outgoing calls.
Type
Options are:
CHAP/PAP - Your ZyWALL/USG accepts either CHAP or PAP when requested by this
remote node.
CHAP - Your ZyWALL/USG accepts CHAP only.
PAP - Your ZyWALL/USG accepts PAP only.
MSCHAP - Your ZyWALL/USG accepts MSCHAP only.
MSCHAP-V2 - Your ZyWALL/USG accepts MSCHAP-V2 only.
User Name Type the user name given to you by your ISP. You can use alphanumeric and -_
characters, and it can be up to 31 characters long.
Password Type the password associated with the user name above. Use up to 64 ASCII characters
except the [] and ?. This field can be blank.
Retype to Type your password again for confirmation.
Confirm
Nailed-Up Select Nailed-Up if you do not want the connection to time out.
Idle Timeout Type the time in seconds that elapses before the router automatically disconnects from
the PPPoE server. 0 means no timeout.
PPTP Configuration This section only appears if the interface uses a PPPoE or PPTP Internet connection.
Chapter 4 Quick Setup Wizards
ZyWALL/USG Series User's Guide
56
@$./