Check Contents - Yamaha DM1000 Service Manual

MODE
CLOCK
FS
END
INPUT button
INPUT route display selection
INPUT route
BUS • AUX buttons
OUTPUT route display selection Selects the route display CHANNEL.
OUTPUT route

3-2. Check contents

Common contents:
1) The IN PORT and OUT PORT are determined by setting the INPUT CH and OUTPUT CH (BUS/AUX).
Mode: Patch setting during ANALOG
INPUT CH
CH1
CH2
CH3
CH4
CH5
CH6
CH7
CH8
CH9
CH10
CH11
CH12
CH13
CH14
CH15
CH16
CH17
CH18
CH19
Changing the input/output terminals
ANALOG Patches the ANALOG I/O to the input/output.
SLOT 1 Patches the SLOT 1 I/O to the input/output.
SLOT 2 Patches the SLOT 2 I/O to the input/output.
2TRD Patches the 2TRD 1, 2 I/O to the input/output.
Changing the clock source
INT 44.1k
INT 48k
INT 88.2k
INT 96k
Displays the operation clock.
Exits the Audio Check mode.
Sets the INPUT CHANNEL to ON/OFF.
The INPUT route of the last CHANNEL set is displayed.
Multiple CHANNELs are not set to ON at the same time.
The voice of the CHANNEL set to ON is output to the C-R monitor (headphones).
Selects the route display.
Displays the outline of the route of the signal selected by the INPUT route display selection.
Sets the OUTPUT CHANNEL to ON/OFF.
The OUTPUT route of the last CHANNEL set is displayed.
Multiple CHANNELs are not set to ON at the same time.
Displays the outline of the route of the signal selected by the OUTPUT route display selection.
IN PORT OUTPUT CH(BUS/AUX)
INPUT1 BUS1
INPUT2 BUS2
INPUT3 BUS3
INPUT4 BUS4
INPUT5 BUS5
INPUT6 BUS6
INPUT7 BUS7
INPUT8 BUS8
INPUT9 AUX1
INPUT10 AUX2
INPUT11 AUX3
INPUT12 AUX4
INPUT13 AUX5
INPUT14 AUX6
INPUT15 AUX7
INPUT16 AUX8
OMNI1
OMNI2
OMNI3
DM1000/MB1000/SP1000
OUT PORT
OMNI1
OMNI2
OMNI3
OMNI4
OMNI5
OMNI6
OMNI7
OMNI8
OMNI9
OMNI10
OMNI11
OMNI12
-
-
-
-
125