Disassembly Procedure; Disassembling The Dm1000; Removing The Sp1000; Removing The Mb1000 - Yamaha DM1000 Service Manual

DM1000/MB1000/SP1000

DISASSEMBLY PROCEDURE

Note: Take care not to trap your fingers.
After replacing the circuit board or fader of FD, please
calibrate the faders. (See page 150.)

Disassembling the DM1000

1.

Removing the SP1000

(Time required: About 2 minutes)
1-1. If the SP1000 is attached to the DM1000, remove
the ten (10) screws marked [A], and then both sides
must be removed. (Fig.1)
2.

Removing the MB1000

(Time required: About 1 minute)
2-1. Remove the two (2) screws marked [B] and loosen
the two (2) screws marked [C]. The MB1000 can
then be removed from the DM1000. (Photo.1, 2)
Photo.1
3. Control Panel Assembly
(Time required: About 7 minutes)
3-1. Remove the SP1000. (See procedure 1.)
3-2. Remove the MB1000. (See procedure 2.)
3-3. Remove the twenty (20) screws marked [60A]. (Fig.2)
3-4. Lift the control panel assembly from the rear side
and fasten them by the stay. (Photo.3-1)
When assembling the control panel assembly
with the bottom assembly, put the screws of
the front side → right side panel side → left
side panel side → rear side in order.
28
SP1000
(MB side pad)
[A]: Bind Head Screw
Fig.1
Meter angle L, R
[B]: Bind Head Screw
[C]: Bind Head Screw
DM1000
SP1000
(Side pad)
[A]
PW 4.0X20 MFZN2BL (VA314000)
MB1000
[B]
[C]
DM1000
A4.0X12 MFZN2BL (VP156900)
A4.0X12 MFZN2BL (VP156900)
Photo.2