Yamaha DM1000 Service Manual page 147

4 In the CATEGORY section, move the cursor to the button of the data type you want to transmit, then press [ENTER].
The following options are available:
• ALL................................. This button selects all data available for bulk dump. When this button is turned on, all other
• SCENEMEM................... This button selects Scene memories. You can select Scenes you wish to transmit in the parameter
• AUTOMIX ...................... This button selects Automix memories. You can select Automixes you wish to transmit in the
• LIBRARY........................ This button selects libraries. You can select the type of library in the TYPE parameter box (next
• BANK............................. This parameter enables you to select the User Defined Key banks (KEYS UDEF), User Defined
• SETUPMEM................... This button selects the DM1000 setup data (i.e., system set-tings).
• PGM TABLE................... This button selects the MIDI | Pgm Asgn page settings.
• CTL TABLE.................... This button selects the MIDI | Ctl Asgn page settings.
• PLUG-IN......................... This button selects the settings of any optional Y56K cards installed in Slot #1 or #2. You can
Note: Data selected by the SETUPMEM button includes MIDI transmission and reception port settings and message
settings. After you store to an external device bulk dump data that has its reception disabled, if the DM1000 later starts to
receive this particular data, DM1000 bulk dump reception will be turned off immediately, and the DM1000 will be unable
to receive subsequent data. Therefore, before you store the data selected by the SETUPMEM button using Bulk Dump,
be sure to enable bulk data transmission and reception.
5 If necessary, move the cursor to the parameter box next to the selected button, then rotate the Parameter wheel or
press the [INC]/[DEC] buttons to select the desired bulk dump data.
Tip: If you selected [ALL] in the parameter box, all data selected by the corresponding button is transmitted as bulk
dump data.
6 To start transmitting bulk data, move the cursor to the TRANSMIT button, then press [ENTER].
Bulk Dump is executed. During the operation, the Bulk Dump window appears, indicating the current bulk dump status. To
abort the bulk dump operation, move the cursor to the CANCEL button in the window, then press [ENTER].
Tip: To transmit bulk dump request messages, move the cursor to the REQUEST button, then press [ENTER]. If a
second DM1000 is connected, it will transmit bulk data to the first DM1000 in response to the request.
7 To receive bulk data, press the DISPLAY ACCESS [MIDI] button repeatedly until the MIDI | Setup page appears, then
turn on the Rx ON/OFF button in the BULK row.
Now, when the DM1000 receives bulk data, the corresponding internal data is updated.
buttons in this section are turned off.
box next to the button.
parameter box next to the button.
to the button), then specify the library number in the parameter box on the right.
Remote Layer banks (RMD UDEF), or User Assignable Layer banks (USR LAYER) for bulk
dump. You can select one of these three types in the parameter box next to the button, and select
the banks in the parameter box on the right.
select Y56K card programs in the parameter box next to the button.
DM1000/MB1000/SP1000
147