Setting The Boiler Set Temperature - Stanley BRANDON Operation Instructions Manual

Press the "F" button again and the red light
moves to set Domestic Hot Water. Each
subsequent time it is pressed the mode will
move on to the next position.
2. The display will be as shown in Fig 4, with the
arrow flashing underneath the day you wish to
program for. The time on the bottom left and
bottom right sides are the ON and OFF times
respectively. The number "1" at the bottom of
the display signifies that these are the times for
the first ON/OFF setting of the day/days.
3. The programs can be set for the individual
days, for weekdays, for weekends and for the
entire week. The days you wish to program for
can be changed by moving the flashing arrow
using the + and - buttons. Fig 5 (a) shows the
day setting for setting the same programme for
Monday to Friday, Fig 5 (b) shows it for setting
the same programme for Saturday & Sunday
and Fig 5 (c) shows it for setting the same
programme for the entire week.
4. After selecting the day, press the " " button
and the 1st ON time will flash. This time can be
adjusted in ten minute intervals using the + and
- buttons.
5. Press the " " button and the corresponding
OFF time can be adjusted using the + and -
buttons.
Note that you cannot set an OFF time to be
earlier than ON time, or the ON time to be
earlier than the previous OFF time. The
programmer will automatically correct settings
if you do this.
6. The 2nd & 3rd ON/OFF times can be viewed by
pressing the " " button and can be set by
repeating Steps 4 & 5
7. Note that if you do not want to use all three
ON/OFF times, simply set the OFF time the
same as the ON time.
8. To exit DHW setting press the "F" button four
times, or press once to edit the Central heating
programs. Press once more to edit the pre-
heat programs in just the same way.
9. To have the appliance operate on the
programmed settings, press the appropriate
button on the right hand side of the control
panel once so that a light can be seen beside
auto.
Fig 5A
Fig 5B
Fig 5C

SETTING THE BOILER SET TEMPERATURE

1. Press the "F" button and hold it for five seconds
until the red "SET DAY/TIME" light illuminates.
Press the "F" button repeatedly until the LED
beside " °C " is illuminated.
The boiler set temperature will be displayed.
2. The boiler set temperature can be adjusted
between the limits 60 – 80 °C by pressing the
+ and - buttons.
6