Table of Contents
Advertisement
SETTING THE ALARM TIMER
The alarm timer allows cooking to be timed up to a
period of 99 minutes. (it does not turn the oven on or
off) The alarm can be set by following the procedure
below:
1.
Press the "alarm" button and a "00 ALARM" will
flash on the display (See Fig 6).
2.
Adjust the alarm time to the desired setting
using the + or - buttons.
3.
The timer will start immediately when the
setting + or - button is released.
4.
When the time has elapsed, the acoustic signal
will sound for 60 seconds and the word Alarm
flashes. It can be cancelled by pressing the
Alarm button.
Note: This timer operates only when the oven is set
to "manual" mode.
BOOST FUNCTION
By pressing the "BOOST" button, boost will be
displayed and the symbols for central heating and
hot water will flash. Then pressing either the "Hot
Water", "Central Heating" or "Pre Heat" buttons will
turn this mode on for 1 hour. The symbols will flash
for 10 seconds and if neither of the 3 options are
selected then the display will revert to current time
Fig 6
and day. If a mode is selected the symbol for this
mode and the word "BOOST" will remain displayed
for 1 hour, providing none of the oven control
functions on the clock are used within this hour.
Boost can be cancelled by pressing the relevant
function button, i.e.
ADVANCE FUNCTION (IN AUTO MODE ONLY)
By pressing the "ADV" button, ADVANCE will be
displayed and the symbols for central heating and
hot water will flash. Then pressing either the "Hot
Water" or "Central Heating" or "Pre-heat" buttons
will bring forward the next switching time for that
mode. The symbols will flash for 10 seconds within
which one of the 3 options must be selected before
the display will revert to current time and day.
Advance can be cancelled by pressing the relevant
function button, i.e.
Note: Advance function is only applicable when
timer is in 'Auto Mode'.
The DHW , Heating and oven Pre-heat programs
can be turned OFF by de-selecting AUTO, so that
no lights are visible.
The DHW and Heating can also be set to
continuous ON by pressing the button so that the
ON light illuminates.
DISPLAY LOCK FUNCTION
By pressing and holding the "LOCK" Button for 10
seconds the display will become locked, and
LOCKED will be displayed. To unlock the display
Fig7
press and hold the "LOCK" button for 10 seconds. If
any button is pressed while the display is locked the
word "LOCKED" will flash on the display.
POWER FAILURE
Your clock has a built-in battery to ensure correct
operation after a mains supply power cut. No action
should be necessary following a power loss.
Fault diagnoses
If an error occurs in the appliance the electronics will
detect it and narrow down the problem area.
Code no 1.
Code no 2.
Code no 3.
Code no 4
Code no 5
7
Oven thermocouple failure
Boiler thermistor failure
Flue thermistor failure (Gas only)
Boiler high limit switch opened
Oven high limit switch opened
Hide quick links:
Advertisement
Table of Contents
