The Boiler; The Programmer - Stanley Brandon OCD User Instructions

THE BOILER

The temperature of the hot water supplied can be
adjusted by means of the boiler thermostat knob. This
knob can also be used to turn the boiler off.
To inhibit internal corrosion of the boiler heat exchanger it
is important not to operate the boiler below 60°C.
An ideal setting for summer hot water, and to keep the
temperature above 60°C, can be achieved using the
'ECO' setting.
'ECO' SETTING
The 'ECO' setting on the boiler is a range at which the
boiler operates at maximum efficiency.
The boiler thermostat knob is situated behind the control
door (See Fig. 2). Turn the knob clockwise to increase the
temperature of the water.
Should your heating water system be of an unvented
design i.e. Pressurised System. It is important not to keep
resetting the boiler safety cut-out as this may indicate a
loss of secondary water.
Check also your system pressure gauge.
FROST PRECAUTIONS
In the event of the boiler being OFF for long periods
during very cold weather, the advice of your installer
should be obtained.
BURNER
The burner can be re-set after 1 minute by pressing the
REPEAT button.
In the event of repeated failure switch off the oil and
electrical supply to the appliance and contact your local
Technical centre or authorised service engineer.

THE PROGRAMMER

WHAT IT DOES
The programmer is a 7-day 2 event programmer which
allows the user to set 2 periods of the day in which the
cooker will turn on and then off. A typical example of how
this may be used is 'on' for use in the morning and then
'off' when going out, and then 'on' if needed for cooking
later in the day and then 'off' when cooking is finished.
The programmer can be set for different time each day
(e.g. morning and evening). However, as many people
have a similar routine through the working week, there is
a repeat function which allows the setting from the
previous day to be copied.
However, it may still be set each day differently.
FUNCTIONS
The AUTO/MAN functions allow the user to turn the
cooker on, by simply turning the knob to the required
cooking mark temperature, or by having it turn on at 2 set
periods within the day.
The minute minder function works as a countdown timer
to ease with cooking. When the timer has counted down
the display will flash 00:00 and a buzzer will sound.
SETTING INDIVIDUAL DAYS
To allow the user to change an individual day without
having to run throughout the entire week, there is the
ability to change just one day (e.g. days holiday) without
altering the previous settings.
SETTING THE TIME OF DAY
: flashes when time is set
Fig. 5
1. Press the CLOCK button once. Adjust the day using +
and -. Press the CLOCK again.
2. Adjust the hour using + and -. Press CLOCK again.
3. Adjust the minutes using + and -. Press CLOCK to
confirm.
The day light will go out.
PLEASE NOTE: Hold + and - down to increase or
decrease.
8
DESN 515996