Setup
Wireless
Operation
Initial Setup
Configuration
Product Pairing
Storage Notes
W-DMX™ Setup
-8-
The WELL™ Flex can operate in W-DMX™ mode up to 50 m (164 ft) from the
W-DMX™ transmitter. The W-DMX™ receiver in the WELL™ Flex must be paired with the
W-DMX™ transmitter for wireless operation.
1. Turn the W-DMX™ transmitter on.
2. Connect the W-DMX™ transmitter to a DMX controller.
3. Place the WELL™ Flex within 50 m from the W-DMX™ transmitter.
4. Disconnect any DMX cable from the WELL™ Flex.
5. Turn the WELL™ Flex on.
1. From the WELL™ Flex's control panel, go to DMX Address.
2. Select the start address, as with any other DMX compatible product.
3. Go to Wireless Setting > Receive.
4. Select On. (The Signal Strength Indicator will show a ? in front of the bars)
5. Press the reset button on the W-DMX™ transmitter. (The Signal Strength Indicator on the
WELL™ Flex will show a ϟ in front of the bars for 3 seconds while a connection is
established.)
If the WELL™ Flex has already been paired with the W-DMX™ transmitter, the Signal Strength
Indicator in the middle of the LCD screen will show the strength of the signal. In this case, the
WELL™ Flex is ready to work in Wireless mode.
Pairing the WELL™ Flex and a new W-DMX™ transmitter:
1. From the WELL™ Flex's control panel, go to Wireless Setting.
2. Select Reset. The Signal Strength Indicator on the WELL™ Flex will show a ? in front of the
bars.
3. From the W-DMX™ transmitter, press <RESET> (the Signal Indicator on the transmitter will
flash).
4. Once the transmitter has found the WELL™ Flex, the Signal indicator on the W-DMX™
transmitter will illuminate solid.
5. The Signal Strength Indicator in the middle of the LCD screen on the WELL™ Flex will
show the strength of the signal.
·
Recharge the battery to full capacity before storing the product.
·
Store charged product(s) in a dry environment, away from direct sunlight.
W-DMX™ operation can be interrupted or inhibited by liquid masses between the
transmitter and receiver such as water, snow, or people. For best results, keep the area
between the transmitter and receiver clear of any liquid mass.
Control Panel
W-DMX™ Transmitter
WELL™ Flex User Manual Rev. 1