Configuration
(DMX)
DMX
Personalities
DMX Control
Wireless Settings
WELL™ Flex User Manual Rev. 1
Use DMX configurations to operate the product with a DMX controller.
This setting allows you to choose a particular DMX personality.
1. Go to the DMX Channel main level.
2. Select the desired personality (4 Ch, 6 Ch, 10Ch, HSI, or HSV).
·
See the
DMX Values
personality.
·
Make sure that the starting addresses on the various products do not overlap due to
the new personality setting.
In this mode, each product will respond to a unique starting address from the DMX controller. All
products with the same starting address will respond in unison.
1. Select a DMX personality as shown in
2. Set the starting address:
a. Go to DMX Address main level.
b. Select the starting address (001–512).
The highest recommended starting address for each DMX mode is as follows:
DMX Personality
4 Ch
6 Ch
10Ch
HSI
HSV
This mode allows you to control DMX wirelessly. For detailed setup of this feature see
Operation. To disable this feature:
1. Go to Wireless Setting > Receive.
2. Select Off.
section for the highest starting address you can select for each
DMX
Personalities.
Operation
DMX Address
509
507
503
510
510
Wireless
-15-