Dmx Linking; Dmx Personalities; Master/Slave Connectivity - Chauvet Well Flex User Manual

DMX Linking

DMX
Personalities
Master/Slave
Connectivity
WELL™ Flex User Manual Rev. 1
You can link the WELL™ Flex to a DMX controller using a 5-pin DMX connection. If using other
DMX-compatible products with the WELL™ Flex, you can control each individually with a single
DMX controller.
The WELL™ Flex uses a 5-pin DMX data connection for the 3-, 4-, 6- and 10-channel DMX
personalities.
·
Refer to the Introduction
·
Refer to the Operation
personalities.
·
The DMX Values section provides you with detailed information regarding the DMX
personalities.
If you are not familiar with or need more information about DMX standards, Master/Slave
connectivity, or the DMX cables needed to link this product to a DMX controller,
download the
http://www.chauvetlighting.com/download/.
The Master/Slave mode allows a WELL™ Flex (the master) to control one or more WELL™
Flex's (the slaves) without a DMX controller. One WELL™ Flex becomes the master when
running an auto program, or by being in a Static mode.
You must configure each slave's control panel to operate in Slave mode. During Master/Slave
operation, the slaves will operate in unison with the master.
DO NOT connect a DMX controller to products operating in Master/Slave mode. The DMX
controller signals may interfere with the signals from the master.
·
Master/Slave mode not available in wireless operation.
·
The Operation section of this manual provides detailed instructions on how to
configure the master and slaves.
chapter for a brief description of each DMX personality.
chapter to learn how to configure the WELL™ Flex to work in these
DMX Primer from the Chauvet
Setup
website:
-7-