Table of Contents
Advertisement
Setup
3. S
ETUP
AC Power
AC Plug
Battery Charge
Notes
Replacing the
Fuse
-6-
Each WELL™ Flex has an auto-ranging battery charger, whether stand-alone or inside the flight
case that works with an input voltage range of 100 to 240 VAC, 50/60 Hz. To determine the
power requirements for each WELL™ Flex, refer to the label affixed to the product. You can
also refer to the
Technical Specifications
The listed current rating indicates the maximum current draw during normal operation. For more
information, you may download Sizing Circuit Breakers from the Chauvet website:
http://www.chauvetlighting.com/download/.
Always connect this product to a protected circuit with an appropriate electrical ground
to avoid the risk of electrocution or fire.
Never connect this product to a rheostat (variable resistor) or dimmer circuit, even if the
rheostat or dimmer channel serves only as a 0 to 100% switch.
The WELL™ Flex comes with a power input cord terminated with a Neutrik® powerCON® A
connector on one end and an Edison plug on the other end (U.S. market). If the power input
cord that came with your product has no plug, or if you need to change the Edison plug, use the
table below to wire the new plug.
Connection
AC Live
AC Neutral
AC Ground
·
Recharge the battery within three days from last use.
·
Recharge the battery to full capacity before storing this product.
·
For best results, charge the battery in a temperature between 32 ºF (0 ºC) and
95 ºF (35 ºC).
·
When charging the battery, keep the product at no less than 1 m from any open flame or
hot plate.
·
When charging the battery inside the road case charger, keep the road case's cover open.
·
Always charge the battery with the product in an upright position.
·
Do not charge the battery for more than 24 hours.
·
Perform a full discharge/recharge cycle every three months.
Be sure to remove rubber plug from the bottom of the product before charging in the
road case.
The WELL™ Flex has no external fuse. However, the road case charger comes with a
replaceable fuse.
1. Disconnect this product from power.
2. Using a flat-head screwdriver, unscrew the fuse holder cap from the housing.
3. Remove blown fuse and replace with a good fuse of the same type and rating.
4. Screw the fuse holder cap back in place and reconnect power.
chart in this manual.
Wire (U.S.)
Wire (Europe)
Black
White
Green/Yellow
Brown
Yellow or Brass
Blue
Green/Yellow
WELL™ Flex User Manual Rev. 1
Screw Color
Silver
Green
Advertisement
Table of Contents
