Fuel Bed Refitting - Coal - Valor 639 Owner's Manual

This section is for models supplied with a 'Coal' effect fuel bed only.
Figure 4. Ceramic Base Location
Figure 5. Front Coal Location
OWNER'S GUIDE

FUEL BED REFITTING - COAL

Place the ceramic base coal in the burner
1.
compartment. The bottom rear face of the
coal should rest against the angled ledge at
the back of the burner tray. The coal does
not rest on top of the angled ledge. The
bottom front edges of the coal base should
locate against the left and right hand side
brackets. (See figure 4).
Place the left-hand ceramic front coal in
2.
position in front of the base coal (See figure
5).
Place the right hand ceramic front coal in
3.
position in front of the base coal. This
should overlap the left-hand coal. Push the
two sides together to minimise the gap. (See
figure 5).
There will be a gap between the rear of
4.
the front coals and the front of the base coal.
(See figure 5).
Page 11
For 'Pebble fuel bed' see
section headed 'Fuel Bed
Refitting – Pebble'.
If the fuel bed components
are dislodged or removed,
they must be refitted as
follows:
Only the fuel bed parts
supplied with this
appliance or authorised
Valor replacements must
be used. Never add extra
coals above the number
stated in these instructions.