Lighting With A Taper - Valor 639 Owner's Manual

• If the flames go out while setting the control, repeat the full lighting procedure.
• If the flames repeatedly go out have the fire serviced.
• Please note. When first turned on the flames will appear predominantly blue.
The coals / Pebbles will take time to warm up. Although some glow will be seen
after approximately ten minutes, the full visual effect will only be apparent after
a somewhat longer time.
• The appliance will operate to its maximum potential if the flue is primed during
the first 20 – 30 minutes of operation. To do this, simply turn the control knob to
its 'HIGH' setting. This will also burn off any carbon deposits that may have
formed during previous operations.
• If operating the appliance for long periods it is beneficial occasionally to change
the settings. This will also help to remove any carbon deposits that may form
during operation.

Lighting with a taper

See figure 3.
In the unlikely event of failure of the
ignition spark, the pilot can be lit by a
taper or long spill.
• Turn the control knob to the 'Pilot
ignition' position
• Insert the taper or spill to the outer
left hand side of the front Coal /
Pebbles.
• Depress the control knob. A flame
should appear at the pilot.
• Remove the taper and keep the
control depressed for 5 seconds.
• Release the control knob and the
pilot flame should remain alight. If
it does not, repeat the above.
• Turn the control knob to the required setting.
OWNER'S GUIDE
Figure 3. Lighting with a taper
Page 9