Fuel Bed Refitting - Valor 641 Owner's Manual

Figure 4. Ceramic Base Location
Figure 5. Front Coal Location
OWNER'S GUIDE
F U E L B E D R E F I T T I N G
(Installer - Note that the small round holes in
the burner plaques that will be covered by the
base coal are not gas burner ports. They are
simply a consequence of the plaque
manufacturing process).
Place the left-hand ceramic front coal in
2.
position in front of the base coal (See figure
5).
Place the right hand ceramic front coal in
3.
position in front of the base coal. This should
overlap the left-hand coal. Push the two sides
together to minimise the gap. (See figure 5).
There will be a gap between the rear of the
4.
front coals and the front of the base coal. (See
figure 5).
Page 11
Place the ceramic base coal
1.
in the burner compartment.
The bottom rear face of the
coal should rest on the angled
ledges at the back of the
burner compartment. The
bottom front edges of the coal
base should locate against the
left and right hand side
brackets. (See figure 4).