Fuel Bed Refitting - Valor BR417 Owner's Manual

If the fuel bed components are dislodged or removed, they must be refitted as follows:
Only the fuel bed parts supplied with this appliance or authorised Valor replacements must be used. Never add extra coals above the number stated in
these instructions.
1.
With its feather edge at
the top, place the ceramic
rear wall into the channel
at the back of the fire box.
Push the wall flat against
the rear of the fire box.
(See figure 4).
2.
Place the two halves
of the front base coal in
the burner compartment
so that they rest on the
ledges at the sides and
front. Pull the coals
forward so that they are
immediately behind the
front rim of the burner
compartment (See fig. 5)
3.
Place the rear base
coal in the burner
compartment behind the
front coal. Its rear face
should touch the
ceramic wall (See figure 6).

FUEL BED REFITTING

Fig. 4 Ceramic rear wall
installation
.
Fig. 5 Front coal installation
rear
Fig. 6 Rear base coal installation
4.
The ceramic side walls
are marked at the rear
bottom corners "L" (Left
side) & "R" (Right side).
Place the side walls against
the sides of the fire box
and in the recesses at the
sides of the base coals.
The markings "L" & "R"
should be at the back
bottom corners and facing
to the centre of the back
of the firebox (See figure
7).
5.
Install the 5 loose
coals as follows. The
smooth surfaces of the
coals should be at the
bottom and back.
5.1
Select the two
largest coals. Place
them in the central
two valleys of the front
coal (See figure 8).
5.2
Place the three
remaining coals behind
and approximately midway
between each of the coals
in the front row (See
figure 9).
7
Fig. 7 Ceramic side walls
installation
Fig. 8 Front row inner coals
Fig 9 Middle row of coals