Fuel Bed Refitting - Valor 719 Owner's Manual

1. Place the rear base coal in the firebox.
It should rest on the ledges at the rear
sides of the burner unit. When located
gently move the rear base coal so that it is
as far forward as possible. The amount of
movement will be negligible (See figure
4).
2. Place the front base coal in the firebox
with its bottom front locating over the
front rim of the firebox. Pull the coal
forward so that it locates immediately
behind the front rim of the
firebox. (See figure 5).The front
base coal will touch the rear base
coal as it is located.
There are two types of loose
coals. These are identified with
the letter "A" or "B" on the
underside of the coal.
There are three "A" coals and
two "B" coals.
3. Place a type "A" coal between
the front and rear base coals with
the letter "A" upright and so that
the coal is against the left side of
the firebox. See figure 6.
OWNER GUIDE

FUEL BED REFITTING

Figure 4. Rear Base Coal Position
Figure 5. Front base
coal position
Figure 6.
Page 10