Fuel Bed Refitting - Ceramic Coals - Valor urban 746 Owner's Manual

OWNER GUIDE
should be removed from the fire for cleaning.
Cleaning should be carried out in a well ventilated area or in the open air by gently
brushing with the pieces held away from your face so that you avoid inhaling the dust.
We suggest that you remove the coals / pebbles in the reverse order to that shown in
the fuel bed refitting instructions.
Burner
The burner surface can be carefully cleaned to remove any loose particles after
taking off the coals / pebbles. Make sure that no particles are pushed into the burner
holes.

FUEL BED REFITTING - CERAMIC COALS

This section is for models supplied with
'Coal' effect fuel bed only.
For 'Pebble fuel bed' see section 'fuel bed
refitting - ceramic pebbles'
1. Place the rear base coal in the firebox. It
should rest on the ledges at the rear sides of the
burner unit. When located gently move the rear
base coal so that it is as far forward as possible.
The amount of movement will be negligible
(See figure 4).
Figure 4. Rear Base Coal Position
2. Place the front base coal in the firebox
with its bottom front locating over the front
rim of the firebox. Pull the coal forward so
that it locates immediately behind the front
rim of the firebox. (See figure 5).The front
base coal will touch the rear base coal as it is
located.
There are two types of loose coals. These are
identified with the letter "A" or "B" on the
underside of the coal.
There are three "A" coals and two "B" coals.
Figure 5. Front base coal position
Page 10