Table of Contents
Advertisement
Heater Tank - Removal and Installation
WARNING! Isolate the electrical and water supplies before removing the cover. Mains
electricity connections are exposed when the cover is removed.
1.
Remove the three cover retaining screws, the cover and the service tunnel.
2.
Remove the hose from the outlet connector and ease the inlet connector off the
inlet supply pipe.
3.
Remove the six screws that hold the inlet clamp bracket, flow regulator assembly,
switch assembly, and heater tank.
Switch Assembly
Flow Regulator
Assembly
36
Screws
Ball
Heater
Tank
Advertisement
Table of Contents
