Related Manuals for Kohler Mira Sport Dual Outlet Shower Fittings
Summary of Contents for Kohler Mira Sport Dual Outlet Shower Fittings
- Page 1 Mira Sport Dual Outlet Shower Fittings For SPARES, ADVICE or REPAIRS please call us free on 0800 001 4040 (UK only) These instructions must be left with the user Installation and User Guide 1555018-W2-A...
-
Page 2: Recommended Usage
Introduction Thank you for choosing a Mira showers. To enjoy the full potential of your new shower fittings, please take time to read this guide thoroughly, and keep it handy for future reference. Guarantee Mira Showers guarantee this product against any defect in materials or workmanship for a period of one year for the shower fittings, and two years for the diverter. -
Page 3: Pack Contents
1 x Lower Bar 1 x Shower Hose Note: Shorter lower bar is available as an accessory. 1554982-W7-A © Kohler Mira Limited, August 2023 2 x Hose Seal 1 x Diverter 1 x Diverter Hose 1.0 m (Longer 1.2 m Fixing Kit... - Page 4 Connector and Note: Shorter lower bar is Diffuser available as an accessory. 1554982-W7-A © Kohler Mira Limited, August 2023 2 x Hose Seal 1 x Diverter 1 x Diverter Hose 1.0 m with Air Pipe, Fixing Kit and Connectors (Longer 1.2 m hose...
- Page 5 General Please read the important safety information and the operation section of this guide before using the shower fittings. Failure to follow the instructions provided with this shower fittings will invalidate the guarantee. 1. Installation of the shower fittings must be carried out in accordance with these instructions by qualified, competent personnel.
- Page 6 9. DO NOT install the shower or fittings where they may be exposed to freezing conditions. 10. The position of the shower fittings must provide a minimum air gap of 25 mm between the showerhead and the spill over level of any bath, shower tray or basin.
-
Page 7: Important Safety Information
Only Kohler Mira recommended accessories should be used. 10. When adjusting the handset mode, point the handset away from body and make sure that the water temperature has stabilised before continuing to shower. -
Page 8: Installation
Installation For ease of Ceiling fitment, allow a minimum of 50 mm from the ceiling in order to fit the riser bar. Mira Shower Minimum 100 mm 300 mm 700 mm Airboost Version Non-Airboost Version Diverter Hose Diverter Hose Diverter Hose Diverter Hose (1.0 m) (1.0 m) - Page 9 u s t 8 mm i s e l i n e a s c e i a t l t h e f r o 8 mm 30 mm Upper Riser Fixing Bracket Lower Riser Fixing Bracket 8 mm Important! Short bottom riser bar is available as an accessory.
- Page 10 Non-Airboost Version Apply a small amount of grease (supplied) Riser Arm to the two seals on middle and lower bar to aid installation. Note: Ensure that both seals are in place for each joint. Push fit the riser arm to the middle bar section.
- Page 11 Offer the riser bar assembly and the diverter to the three wall fixing brackets. If necessary, adjust the wall bracket position to the correct places. Locking Peg on top side Remove the riser bar assembly and fit the concealing covers onto each of the riser bar wall brackets.
- Page 12 Connect the Diverter Hose Link (1.0m): Important! Connect the clear conical end (with unique thread) to the diverter inlet. Connect the green conical end (with standard thread) to the shower outlet. If the diverter link hose is not long enough for your installation, please Contact Mira Customer Service to receive a longer Green...
- Page 13 Airboost Version Riser Arm Middle Bar Air Pipe Yellow Assembly Lower Bar Apply a small amount of grease Yellow Assembly Aid (supplied) to the two seals on middle and lower bar to aid installation. Place the yellow assembly aid on one Note: Ensure that both seals are end of the air pipe.
- Page 14 Remove the yellow assembly aid. Attach the diffuser to the outlet side end of air pipe and air pipe connector to the diverter side. Slide the hose retaining ring onto the lower bar section. Diffuser Push fit the air pipe connector to the female connector inside the top of the diverter.
- Page 15 Offer the riser bar assembly and the diverter to the three wall fixing brackets. If necessary, adjust the wall bracket position to the correct places. Locking Peg on top side Remove the riser bar assembly and fit the concealing covers onto each of the riser bar wall brackets.
- Page 16 Connect the Diverter Link Hose Note: Make sure air pipe Adapter is Air Pipe pushed fully Connector home. Hose Green Washer Conical Clear Conical Air Pipe Clear Hose Connector Conical Washer Green Conical To enable the airboost function that the shower hoses must now be fitted correctly. Note: The clear conical end (unique thread) connects to the diverter inlet and the green conical end (standard thread) connects to the shower outlet.
- Page 17 Connect the Shower Hose: Green Conical Air Pipe Connector Diffuser Note: The red conical end with air pipe connector connects to the diverter outlet and the green conical end (or with white label) with air pipe diffuser connects to the showerhead. Air Pipe Connector Fit the air pipe connector to the diverter outlet...
- Page 18 Screw the fixed shower head onto the riser arm. Note: Ensure the diffuser is in place. Diffuser Important! Before using your new fittings please make sure to commission the shower following the manufacturers instructions. 1555018-W2-A...
-
Page 19: Operation
Operation The diverter lever operates as shown below: Control Lever Position 1 - Water comes out of the showerhead. Control Lever Position 2 - Water comes out of the overhead. Note: When diverting from showerhead to overhead a small amount of cold water may initially flow. - Page 20 Clamp Bracket Operate the lever and slide the clamp bracket up and down until it is positioned at the desired height and lock in position. 1555018-W2-A...
- Page 21 Cleaning Always read the IMPORTANT SAFETY INFORMATION for your shower. Cleaning the Showerhead Many household and commercial cleaners, including hand and surface cleaning wipes contain abrasives and chemical substances that can damage plastics, plating and printing and should not be used. These finishes should be cleaned with a mild washing up detergent or soap solution, and then wiped dry using a soft cloth.
- Page 22 Airboost Version Unscrew the shower hose from the shower then pull the air pipe connector from the shower outlet. Connector Unscrew the shower hose from the showerhead, pull out the pipe diffuser. Ensure the diffuser holes are free from scale, clean if necessary.
- Page 23 Spray Modes Mode 1 Mode 2 Mode 3 Mode 4 When adjusting the shower spray mode, DO NOT force the lever as product damage will occur. 1555018-W2-A...
-
Page 24: Customer Support
Kohler Mira Limited. Cromwell Road, Kohler France S.A.S. Cheltenham, 30 Boulevard de la Bastille, The company reserves the right Gloucestershire 75012 Paris, to alter product specifications GL52 5EP France without notice. 14648 1555018-W2-A © Kohler Mira Limited, October 2023...