Kohler STEWARD ECO Installation Instructions Manual

0.5l touchless urinal rear inlet

Advertisement

Quick Links

BEFORE YOU BEGIN
BEFORE YOU BEGIN
·
Please read these instructions carefully to familiarize
yourself with the required tools, materials, and installation
sequences. Follow the sections that pertain to your
particular installation. This will help you avoid costly
mistakes. In addition to proper installation, read all
operating and safety instructions.
·
All information in these instructions is based upon the
latest product information available at the time of
publication. Kohler China reserves the right to make
changes in product characteristics, packaging, or
availability at any time without notice.
·
These instructions contain important care, cleaning, and
warranty information -
consumer
.
·
Observe all local plumbing and building codes.
·
Carefully inspect the new urinal for damage.
·
Site preparation may require additional tools and
hardware.
CAUTION: Risk of personal injury or product
damage.
Handle with care. Vitreous china can break
or chip if the product is handled carelessly.
RECOMMENDED TOOLS AND MATERIALS (NOT SUPPLIED)
RECOMMENDED TOOLS AND MATERIALS (NOT SUPPLIED)
·
Open end/adjustable wrenches
·
Tape measure
·
Basin wrench
·
Pipe wrench
·
Square
·
Level
·
Pliers
·
Socket wrench with sockets
·
Screw driver
·
Seal tape
·
Connection wire
·
Wire cutter
·
Insulation tape
·
Bushing
·
Drill
·
Sealant
1145740-T01-B
please leave instructions for the
0.5L TOUCHLESS URINAL (REAR INLET)
·
·
·
·
·
·
·
/
·
·
·
·
·
·
·
·
·
·
·
·
·
·
·
528137
-1-
STEWARD ECO
INSTALLATION INSTRUCTIONS
0.5
K-4888T(
(
)
Copyright Kohler China Ltd., 2010
)
-
, 2010

Advertisement

Table of Contents
loading

Summary of Contents for Kohler STEWARD ECO

  • Page 1 · · All information in these instructions is based upon the latest product information available at the time of publication. Kohler China reserves the right to make changes in product characteristics, packaging, or availability at any time without notice. ·...
  • Page 2: Specifications

    2" NPT Tap " 2 Wall 2" NPT Tap Floor " 2 Spud Detail Kohler reserves the right to change marked dimensions without prior notice. Fig.1 · · Roughing-in dimensions are identical if using an optional 3" 3"outlet spud. ·...
  • Page 3: Prepare The Site

    Notice: To ensure an effective flush performance, 25mm strongly recommended inner diameter of ) 0.18MPa ~0.55MPa water supply (including water meter, valve, etc.) is no less than 25mm, and supplied water pressure (sensor inlet dynamic pressure) is 0.18MPa ~0.55MPa. PREPARE THE SITE PREPARE THE SITE NOTE: If a pre-existing waste pipe will be used and will result...
  • Page 4 B. Install urinal 1. Install the sprayer and the adapter a. Insert the sprayer into the hole, with the guide hole in the middle. b. Install the gasket and screw the nut tight. Fig.4 c. Install the adapter and make the inlet at a 90 degree angle to the left, as shown in Fig.
  • Page 5 b. Install the manual button. Insert the button into the hole, then put on the washer and the nut. Fig.10 c. Connect with the hose. Fig.11 4. Install the sensor controller Spring a. Install the sensor controller box. b. Install the spring. c.
  • Page 6 USER S GUIDE USER S GUIDE Illustrations The urinal will automatically flush after using. Fig.14 Replacement of Batteries When the batteries run out, please remove the Battery Box Assembly by following the instructions in step C and then replace the batteries. Battery Box Assy.
  • Page 7: Maintenance

    Manual Flushing Press the manual button for about 2 seconds and the urinal will automatically flush once. Sensorless Cleaning Mode Enter or exit the sensorless cleaning mode by pressing the manual button for over 5 seconds. Under this mode, press the manual button for about 2 seconds to control the urinal to flush or stop flushing.
  • Page 8: Troubleshooting

    TROUBLESHOOTING Please make following checks before repair: Symptoms Probable causes Corrective actions 1. No power or mistake connected. 1. Check the power connect. No flushing 2. Not able to detect the urine. 2. See user's guide. 3. Out of electricity. 3.

This manual is also suitable for:

K-4888t

Table of Contents