Table of Contents
Advertisement
12. Secure the shower to the wall
loosely through the top two fixing
holes, using the supplied screws.
13. Mark the position of the bottom
fixing hole.
14. Remove the shower from the wall.
Drill the bottom fixing hole and insert
the supplied wall plug.
15. Thoroughly flush the mains-fed
cold water supply pipe.
supply must be clean and free
from debris BEFORE connecting
the appliance.
16. Replace the shower on the wall and
secure through the three fixing holes,
using the supplied screws.
17. Connect the inlet supply pipe to the
inlet connector using a 1/2" BSP
nipple with compression nuts and
olives (shown) or a push-fit
connector.
The
Inlet Connector
Compression
Nut
Olive
1/2" BSP Nipple
Olive
Compression
Nut
Inlet Supply Pipe
18
Screws
Advertisement
Table of Contents
