Table of Contents
Advertisement
8.
Determine the direction of the
incoming water supply: falling
(entering the shower from the top),
or rising (entering the shower from
the bottom).
Do not use an incoming supply
entering the shower directly from
the back. Add an elbow to the supply
pipe and connect it as a rising or
falling supply.
9.
Rotate the inlet connector to suit the
direction of the incoming water
supply.
10. The case has thinned sections that
can be removed to allow entry of the
supply pipe and electrical cables.
Remove the top thinned section of
the case for a falling supply, or
remove the bottom thinned section
of the service tunnel for a rising
supply.
11. Do not remove any case if the
electrical cables enter from the back.
Thinned
Section
Service Tunnel
17
Inlet Connector
Thinned
Section
Advertisement
Table of Contents
