Log File Setting Items (For Trace) - Panasonic FP7 User Manual

Configuration

2.3.2 LOG FIle Setting Items (For Trace)

 The following items are set in the LOG file settings dialog box.
 Setting items
Item
File
Application
Autostart
File output format
Logging trigger
Bit device
Cycle
Instruction
Stop trigger
No. of samplings
after stop trigger
detection
File write
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.ctiautomation.net - Email: info@ctiautomation.net
2-10
Setting range Description
Within 32 one-byte
Enter a file name to be saved in a selected LOG number.
characters
Trace Select Trace.
Yes: Trace operation starts when changing to the RUN mode.
Yes / No
No: Trace operation is started by the operation of
programming tool or the LOGST instruction in user programs.
CSV Select CSV.
Select a condition to start logging data.
Specify an arbitrary Select this for setting bit conditions as logging trigger. Press
bit device. the "Set" button, and select a device type and a number.
Select this for setting time as logging trigger. Input a cycle for
executing trace.
1 second, 2 seconds, 3 seconds, 4 seconds, 5 seconds, 6
Time data
seconds, 10 seconds, 15 seconds, 30 seconds, 1 minute, 2
minutes, 3 minutes, 4 minutes 5 minutes, 6 minutes, 10
minutes, 15 minutes, 30 minutes, 1 hour, 2 hours, 3 hours, 4
hours, 6 hours, 12 hours, 24 hours
Trigger conditions occur by executing the SMPL instruction
-
under arbitrary conditions in user programs.
Stops Trace.
Press the "Set" button to specify a device type, a number and
Bit
the number of samplings after the detection of stop trigger.
Buffer full Trace operation stops once the buffer is full.
Specify the number of samplings after the detection of stop
0-262144
trigger.
On completion of trace operation, executes writing data into
Automatic
an SD memory card.