The length and quality of the cable may have negative repercussions on the quality
of the signal.
Use an Ethernet cable complying with the following remarks:
• A straight cable is recommended.
• Use a good-quality cable: as a minimum, a category 5 (STP Cat 5) or higher
shielded twisted pair cable.
• The maximum permitted length of the Ethernet cable is 100 m per segment.
Upon delivery, the IP configuration parameters for the WebdynRF gateway are
as follows:
IP address: 192.168.1.12
Sub-network mask: 255. 255. 255.0
DHCP: Deactivated
Network administrator
If your local network is managed by a network administrator, contact him before
integrating the WebdynRF gateway into your network.
5.2.2
Internet connection via a GPRS or 3G link
To use a GPRS link or a 3G link and to enable the gateway to communicate with the
remote server, you need to insert a SIM card into the gateway's internal drawer.
WebdynRF – Installation Manual - Version 1.0
Modem/Router
WEBDYN
WebdynRF
Installation Manual
FTP server
15
Need help?
Do you have a question about the WebdynRF and is the answer not in the manual?