Incoming Call Blocking - Epygi Quadro6L Extension User Manual

Quadro6L/4L Manual III: Extension User's Guide Extension User's Menus
The Enable Service checkbox selection hides the current
extension's information when calling to the corresponding
Address listed in the Caller ID Based Services table.
Please Note: Even if the Hiding Caller Information
service is enabled, it shall work only for internal PBX calls
and SIP calls. If you call through ISDN port to a PSTN
number, the called party will still see your caller ID. To hide
your caller ID for PSTN destinations, contact your PSTN
operator.
Fig. III-22 Hiding Caller Information page

Incoming Call Blocking

Incoming Call Blocking allows blocking unwanted incoming calls for a Quadro extension. This page provides the necessary settings for incoming
call blocking. It indicates if the service is enabled for the particular caller and whether or not the custom message will be used to inform the caller
about the call being blocked. If the service for the particular caller has been enabled by the administrator and has been stated as protected, the user
cannot disable it.
Please Note: The administrator can protect the service from being disabled by you. Contact the administrator if callers complain that they cannot
reach you.
The Enable Service checkbox selection blocks all calls to the current extension using the corresponding Address listed in the Caller ID Based
Services table where the Incoming Call Blocking service is configured.
The Send Message to Caller Party checkbox is available when the service is enabled and initiates a message to inform the caller that their line has
been blocked. Otherwise, the calling party will be disconnected without notification.
The Restore Default Blocking Message File restores the default incoming call blocking message if another user-defined file has been previously
selected. When the checkbox is selected, the file upload possibility will be disabled.
The Upload New Blocking Message File requires the name of
the desired voice message file. The file needs to be in PCMU
(CCITT u-law, 8 kHz, 8 bit Mono) wave format, otherwise the
system will prevent uploading it and the "Invalid audio file, or
format is not supported" warning message will be received. The
system also prevents uploading if there is not enough space
available for the corresponding extension. You will then receive
the "You do not have enough space" warning.
Browse is used to browse custom voice message used for
incoming call blocking.
The Download Custom Blocking Message File link only
appears if a file has been previously uploaded. The link is used
to download the audio file to the PC and opens a window where
the saving location can be specified.
Fig. III-23 Incoming Call Blocking page
Quadro6L/4L; (SW Version 5.2.x)
29