Yamaha 2012 TMAX XP500A Service Manual page 101

1. Meter lead
2. Ambient temperature sensor lead
3. ABS ECU coupler
4. Fuse box (left)
5. Fuse box lead
6. Lean angle sensor lead
7. ECU (engine control unit) lead
8. Hydraulic unit assembly
9. Wire harness
10.Handlebar switch lead
A. Install the fuse box (right) securely to the
plastic stay.
B. Insert the wire harness holder into stay 1.
C. Connect the front wheel sensor lead to the
connector attached to the wire harness.
D. Fasten the starter relay lead to the plastic
stay. Route and insert the handlebar switch
lead inside the vehicle.
E. Fasten the right and left handlebar switch
couplers to the plastic stay.
F. Insert the wire harness holder (with white
tape) into stay 1.
G. Route the horn lead and front wheel sen-
sor lead as shown in the illustration.
H. Fasten the right and left handlebar switch
leads and insert them into stay 1. The
ratchet may be faced to any direction.
I. Route the right and left handlebar switch
leads between stay 1.
J. Pass the handlebar switch leads through
the holder. The opening can be oriented in
any direction.
K. Install the holder between the wire harness
holder and meter lead. The opening can be
oriented in any direction.
L. The left and right handlebar switch leads
can be positioned in either way.
M. Detailed illustration of the steering head
pipe front side routing
N. Inside of stay 1.
O. Connect to the coupler fastened to the wire
harness.
P. Insert the wire harness holder into stay 1
from the inside of the vehicle.
Q. Route the front wheel sensor lead further
to the left of the vehicle than the right and
left handlebar switch leads.
R. Insert the wire harness holder into stay 1.
S. Right side
T. Insert the front wheel sensor lead holder
into stay 1.
U. Insert the front wheel sensor lead holder
into stay 1. Face the opening to the top of
the vehicle.
V. Left side
2-46
CABLE ROUTING