Snmp > Trap To Smartconsole; Snmp > Snmp > Snmp Global Settings - D-Link SmartPro DGS-1500-20 User Manual

5 Configuration
D-Link Web Smart Switch User Manual
SNMP > Trap to SmartConsole
The Trap to SmartConsole page allows user the set the difference status of SNMP notifications trapped to
the Smartconsole.
Figure 5.93 – SNMP > Trap to SmartConsole
Destination IP: Specifies the destination IP.
Illegal Login: Specifies the device to send illegal login notifications.
Device Bootup: Specifies the device to send bootup notifications.
Port Link Up/Link Down: Specifies the device to send notifications when port linkup or link down.
RSTP Port State Change: Specifies the device to send notifications when RSTP port state changes.
Firmware Upgrade State: Specifies the device to send notifications when firmware upgrades.
Duplicate IP Detected: Specifies the device to send notifications when duplicate IP were detected.
CPU Utilization: Specifies the device to send CPU utilization notifications.
SNMP > SNMP > SNMP Global Settings
Simple Network Management Protocol (SNMP) is an OSI Layer 7 (Application Layer) protocol designed
specifically for managing and monitoring network devices. SNMP enables network management stations to
read and modify the settings of gateways, routers, switches, and other network devices. Use SNMP to
configure system features for proper operation, monitor performance and detect potential problems in the
Switch or LAN.
Managed devices that support SNMP include software (referred to as an agent), which runs locally on the
device. A defined set of variables (managed objects) is maintained by the SNMP agent and used to manage
the device. These objects are defined in a Management Information Base (MIB), which provides a standard
presentation of the information controlled by the on-board SNMP agent. SNMP defines both the format of the
MIB specifications and the protocol used to access this information over the network.
The default SNMP global state is disabled. Select Enable and select Trap Settings then click Apply to
enable the SNMP function.
Figure 5.94 – SNMP > SNMP > SNMP Global Settings
Trap Settings: Specifies whether the device can send SNMP notifications.
68