Config Ipif System - D-Link SmartPro DGS-1500-20 User Manual

6 Command Line Interface
Restrictions
Example usage:
To upload a firmware file:
DGS-1500-28>upload firmware_toTFTP 1.1.1.23 1\running—config
01–Jan–2000 01:26:11 %COPY–I–FILECPY: Files Copy – source URL
running–config destination URL tftp://1.1.1.23/1\running–config
.....01–Jan–2000 01:26:16 %COPY–W–TRAP: The copy operation was
completed success fully
!
158 bytes copied in 00:00:05 [hh:mm:ss]
DGS-1500-28>

config ipif system

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure the IP interface System:
DGS-1500-28> config ipif System ipaddress 10.48.74.122/8
Success.
DGS-1500-28>
TFTP server.
cfg_toTFTP − Specifies that the Switch's current settings will be
uploaded to the TFTP server.
tftp://ip-address/ − The IP address of the TFTP server.
filename − The filename of the firmware or switch configuration
file on the TFTP server. You need to specify the DOS path if the
file is not at the root directory of the TFTP server.
None.
To configure the System IP interface.
config ipif system { ipaddress <ip-address> <subnet-mask>
gateway <gw-address> | dhcp }
The c onfig ipif s ys tem command configures the System IP
interface on the Switch.
ipaddress <ip-address> <subnet-mask> − The IP address and
subnet mask to be created. Users need to specify the address
and mask information
example,10.1.2.3/255.0.0.0)
gateway <gw-address> − The IP address of the router or
gateway.
dhcp − Allows the selection of the DHCP protocol for the
assignment of an IP address to the Switch's System IP interface.
None.
80
D-Link Web Smart Switch User Manual
using the traditional format (for