Cancelling Auto Exposure Bracketing - Kodak DCS Pro SLR/n User Manual

Controlling Exposure
Cancelling Auto Exposure
Bracketing
7-22
3. Compose the picture, focus, and capture the image.
The compensated shutter speed and aperture values appear in the Top
LCD and viewfinder during capture.
Auto Exposure Bracketing behaves differently in the following
situations:
• If Exposure Compensation or Flash Exposure Compensation is also set,
bracketing is combined with the exposure compensation values. It is
useful to perform bracketing with a compensated value over +2 EV or
under -2 EV.
• With Drive mode in Continuous Shooting (see
and hold the Shutter Release button until you have captured the set
number of images.
• If the memory card becomes full during Bracketing, you can capture the
remaining images after inserting a new card. Also, if you turn the
camera off during Bracketing, you can capture the remaining images
after turning the camera on again.
• When the Self Timer (see
frame at a time.
• Press and hold
disappears from the Top Status LCD. Alternatively you can perform
Two-Button Reset (see
If you cancel using the Main-Command dial, the number of shots and
the compensated EV values will automatically be selected the next time
you use Auto Exposure Bracketing. If you cancel using Two-Button
Reset, values are reset to 3F 0.5.
page 5-26) is set, bracketing is performed one
. Rotate the Main-Command dial until
page 5-23).
page 5-25), fully press
April 29, 2004