Kodak DCS Pro Back Plus Supplementary Manual

Mamiya interface plate

Hide thumbs Also See for DCS Pro Back Plus:

Download this manual See also: User Manual

MAMIYA Interface Plate

To use the KODAK PROFESSIONAL DCS Pro Back or DCS Pro Back Plus (Pro Back/Pro Back Plus)

with the MAMIYA RZ67 PRO II camera body (MAMIYA camera body), you must first attach the

MAMIYA Interface Plate to the camera body.

1. Insert the four studs on the MAMIYA camera body into the four holes on the MAMIYA Interface

Plate.

2. Slide the Lock handle downward to secure the plate to the camera body.

3. Turn the lever on the Cable Release plug to O. (Refer to the picture on page 3.) Insert the plug into the

auxiliary release jack on the front of the RZ67, then turn the lever to L to lock the plug. (When

removing the cable, turn the lever from L to O and pull the plug out.)

P/N 6B5813

lever

Lock handle

August 24, 2001

Page 1: Mamiya Interface Plate
MAMIYA Interface Plate To use the KODAK PROFESSIONAL DCS Pro Back or DCS Pro Back Plus (Pro Back/Pro Back Plus) with the MAMIYA RZ67 PRO II camera body (MAMIYA camera body), you must first attach the MAMIYA Interface Plate to the camera body.
Page 2 4. Attach the Pro Back/Pro Back Plus to the MAMIYA Interface Plate as described in the DCS Pro Back or DCS Pro Back Plus User’s Manual. 5. Once the Pro Back/Pro Back Plus is attached, lock the Shutter Release on the camera body by rotating the Shutter Release lock as described in your RZ67 PRO II instruction manual.
Page 3 Electromagnetic Cable Release Orange dot Long time White dots Release button Release Button The Release button is a two-step position button. Each position provides a different function. • Lightly press the Release button halfway down to collect photometric data. • Press the button fully down to perform a shutter release.

Dcs pro back - mamiya interface plateDcs pro back