Inspecting And Cleaning The Imager - Kodak DCS Pro SLR/n User Manual

Camera Care
Inspecting and Cleaning the
Imager
14-4
CAUTION
:
It is important that you follow these instructions when
inspecting and cleaning the imager. Failure to do so can
damage your camera.
1. Turn off the camera.
2. Remove the lens from the camera.
3. Power on your camera using a fully charged battery.
CAUTION
:
If the battery loses charge during the cleaning procedure,
the shutter can close and damage your camera.
4. Put the camera in Manual Exposure mode (M). See
5. Choose Imager Clean from the Tools menu then choose Open.
6. Press the OK button.
The mirror raises and the shutter opens.
7. Inspect the imager according to the Technical Information Bulletin
(TIB) procedure at www.kodak.com/go/dcs.
8. Choose Imager Clean from the Tools menu then choose Close.
9. Press the OK button.
The shutter closes and the mirror returns.
10. Turn off the camera.
11. Replace the lens.
page 7-15.
April 29, 2004