Inspect Swing Arm And Rear Axle - Victory Motorcycles Hammer 2005 Owner's Manual

Rear Suspension

Inspect Swing Arm and Rear Axle

1. Remove the swing arm pivot covers and tighten the swing arm pivot nut.
Torque: 85 ft-lbs (115 Nm)
2. Reinstall the pivot nut covers.
3. Sit in the operator's seat and slowly bounce the rear suspension a few times. Make sure the suspension moves
freely without binding.
4. Elevate the rear of the motorcycle until the rear wheel is off of the ground. Use an appropriate motorcycle lift or
a block of wood or steel placed securely under the frame.
5. Grasp the rear tire and attempt to move the rear wheel side-to-side.
NOTE: If there is movement at the rear axle, inspect the wheel bearings and rear axle (see the VICTORY
Service Manual or an authorized VICTORY dealer).
If there is movement at the front of the swing arm, check the swing arm pivot nut torque. If movement is still
present, inspect the swing arm pivot bushings (see the VICTORY Service Manual or an authorized VICTORY
dealer).
6. With the transmission in neutral, slowly rotate the rear wheel. If the wheel does not rotate smoothly, inspect the
wheel bearings, rear axle, belt adjustment, and wheels alignment (see the VICTORY Service Manual or an
authorized VICTORY dealer).
MAINTENANCE
97