Installing The System Board - IBM System x3200 Type 4362 Problem Determination And Service Manual

10. If you are instructed to return the system board, follow all packaging

Installing the system board

To install the system board, complete the following steps.
System board
mounting screws
(10 places)
1. Insert the system board into the chassis and slide it toward the rear of the
2. Install the seven screws that secure the system board to the chassis.
3. Install any of the following components that you removed from the system
4. Press and hold the retaining tab on top of the cage; then, rotate the drive cage
5. Reconnect any cables to the system board that you disconnected during
6. Install the side cover (see "Installing the side cover" on page 40).
7. Lock the side cover if it was unlocked during removal.
8. Reconnect the external cables and power cords; then, turn on the attached
94
System x3200 Types 4362 and 4363: Problem Determination and Service Guide
instructions, and use any packaging materials for shipping that are supplied to
you.
server until it fully engages the tabs in the chassis.
Note: The tabs are fully engaged when the screw holes in the system board
are aligned with the corresponding holes in the chassis.
board:
v SAS/SATA controller (see "Installing the SAS/SATA controller" on page 85).
v Battery (see "Installing the battery" on page 69).
v DIMMs (see "Installing a memory module" on page 68).
v Microprocessor and fan sink (see "Installing a microprocessor and fan sink"
on page 91).
v Adapters (see "Installing an adapter" on page 46).
into the chassis until it locks into place.
removal.
devices and turn on the server.