Removing A Memory Module - IBM System x3200 Type 4362 Problem Determination And Service Manual

Removing a memory module

To remove a dual inline memory module (DIMM), complete the following steps.
1. Read the safety information that begins on page vii and "Installation guidelines"
2. Turn off the server and all attached devices; then, disconnect all power cords
3. Unlock and remove the side cover (see "Removing the side cover" on page 39).
4. Disconnect any cables that impede access to the DIMMs.
5. Locate the DIMM connector that contains the DIMM that is to be replaced (see
6. Carefully open the retaining clips on each end of the DIMM connector and
7. If you are instructed to return the DIMM, follow all packaging instructions, and
on page 35.
and external cables.
"System-board optional-devices connectors" on page 11 for DIMM slot
locations).
Attention: To avoid breaking the DIMM retaining clips or damaging the DIMM
connectors, open and close the clips gently.
remove the DIMM.
use any packaging materials for shipping that are supplied to you.
Chapter 4. Removing and replacing server components
67