IBM System x3200 Type 4362 Problem Determination And Service Manual page 36

v Date and Time
v System Security
v Startup Option
18
System x3200 Types 4362 and 4363: Problem Determination and Service Guide
Select this choice to disable or enable the internal diskette drive.
– Mouse
Select this choice to specify whether the mouse is installed or not installed.
– Planar Ethernet
Select this choice to disable or enable the Ethernet on the system board.
– System MAC Address
Select this choice to view the MAC addresses for network devices that are
installed in the server.
– Parallel ATA
Select this choice to disable or enable the Parallel ATA.
– Serial ATA
Select this choice to disable or enable the Serial ATA.
– Native Mode Operation
Select this choice to configure the Native Mode Operation.
– SATA Controller Mode Option
Select this choice to configure the SATA Controller Mode Option.
– SATA AHCI
Select this choice to configure the SATA AHCI. This selection is hidden if the
SATA Controller Mode Option is set to compatible.
– Video
Select this choice to view the video information.
Select this choice to set the date and time in the server, in 24-hour format
(hour:minute:second).
This choice is on the Configuration/Setup Utility menu only.
Select this choice to set password settings. See "Using passwords" on page 20
for more information about passwords. You can also enable the chassis intrusion
detector to alert you each time the server cover is removed.
– Administrator Password
This choice is on the full Configuration/Setup Utility menu only.
Select this choice to set or change an administrator password. An
administrator password is intended to be used by a system administrator; it
limits access to the full Configuration/Setup Utility menu. If an administrator
password is set, the full Configuration/Setup Utility menu is available only if
you type the administrator password at the password prompt.
– Power-on Password
Select this choice to set or change a power-on password.
Select this choice to view or change the startup options. Changes in the startup
options take effect when you restart the server.
You can set keyboard operating characteristics, such as the keyboard speed, and
you can specify whether the server starts with the keyboard number lock on or
off.
You can enable a virus-detecting test that checks for changes in the boot record
when the server starts.
– Startup Sequence Options